![]() ![]() Prior to further disassembly with your finger off of the trigger and outside of the trigger guard, point the pistol in a safe direction, lock the slide open by pushing up on the slide stop lever while pulling the slide to the rear with the non-shooting hand (Figure 7). For this reason you will hove to rotate the hand a few degrees to be able to press the catch and release the magazine. ![]() The GLOCK pistol is designed so that the magazine catch can not easily be pressed unintentionally when the pistol is held in a proper shooting grip. PRESS in on the magazine catch (Figure 6).POINT the pistol in a safe direction (a safe direction is where no one can possibly be injured in the event of an accidental discharge)-Finger OFF of trigger and OUT of the trigger guard.PRIOR TO FIELD STRIPPING, MAKE SURE PISTOL IS UNLOADED Magazine Removal NOTE: Performance levels may change when using different firearms. Handloaded/relt>aded or re-manufactured ammunition may be unsafe and voids factory warranty. Maximum (upper limit) pressures for 9 x 19mm ammunition to be used in Glock pistols should not exceed 43,500 pounds per square inch/3000 BAR Minimum (lower limit) specifications for ammunition to be used in Glock pistols: (GLOCK pistols will function properly with the new generation of 9x19mm ammunition including all +p+ and 147 grain sub-sonic ammunition currently being introduced in the United States.) Any deviation from these specifications may lead to improper functioning and possibly void the warranty on GLOCK pistols. Therefore the following guidelines and specifications are provided so that proper ammunition will be selected for use in GLOCK pistols to assure proper functioning. GIOCK pistols are designed to be fired with NATO specification ammunition. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |